What is LAIDONG fuel filter and Why Do We Use Them?

pjr,

If you want to learn more, please visit our website Yuchung Power.

  I also purchased a 254 from Keno Tractors in July.  It came with the oil reading about 1/8 of an inch over the high mark on the dip-stick.  I think that's the way it reads when you add the amount of oil ( with filter change ) as listed on the data sheet we received.  I'm about ready to do my first oil change also.  Will let you know my results.

Thanks tone……mine wasnt over an 1/8th when I bought it but when I did the oil change its about a inch over the high mark and I only put 6 quarts in it and left the little over out or the .38. I was sure it wasnt a “check when running  deal” but why else would it be that far over. I replaced the filter as well and im asuming that the little over 6 quarts is what makes up the dry filter. Im running it with the inch over for now and it seems to be fine so idk. Thanks

I do not know if yours might do as mine but if I pull the dipstick and look at it ,it will show low ,I need to wipe it off and place it back pull it again to get a good reading.I guess it forms a vaccum on the dipstick tube after engine cool off from last use.That is the 50 hp foton the 20 hp dong feng does not do it. I will say this I go by the dipstick not the book.

When I dropped the oil it didnt have but maybe 4 in 1/2 quarts it looked to me so if I go by the dip stick an not the book then it could be under what it needs. It could easly have the wrong length dipstick tube or even wrong dipstick which would cause a false reading. So………thats why id like to get this correct. As for the rechecking….Ive done that one thinking the same thing as David mentioned and I get the same reading. Really…..5 to 6 quarts sounds more like what this size engine needs and not 4 1/2 or so. Im thinking I might give Keno Tractor a call and see what they got to say about it and ill let you know what they say. thanks

Featured content:
10 Common Questions That Homeowners Ask About Roofing

For more LAIDONG fuel filterinformation, please contact us. We will provide professional answers.

Len10 you very well could be right. That's probably what was the amount that was dropped when I changed the oil.I know it looked a whole lot less then what keno's data sheet recommended. So that being said….and after doing some more research it probably does take only 3.6 quarts and would proly put me on the mark with the dip stick. I'll have to drain a little out an next oil change figure out how much it is to the full on the stick an if its 3.6 or so then I'd feel confident in that. Thanks everyone for the help and the comments. I'll update when I call keno an get a day off to figure it out.

ok……so I called Keno T this morning and they told me that they havent updated there data sheet in a while and these newer 385 engines take less oil i guess. He couldnt give me the exact amount but he thought around 4 quarts. He told me to go by the dip stick. So tomorrow on my day off ill drain it to the full mark an see how much I get out and that should tell me close to what it takes for next oil change.

My next issue is getting new filters. I gave napa my filter number off the filter and they cant find anything that crosses over. I think Tone-tone is having the same issue. Its a JX on my filter too. I got Keno looking that up for me now and ill let you know.

Dear users:     Hello! Thank you for choosing laidong diesel engine. Diesel engine has good long-term reliable performance, design and manufacturing is the foundation, maintenance and use is the key. So, with reading power "diesel engine maintenance manual" and "maintenance manual you must". In strict accordance with the requirements of use and maintenance.     1 before starting to check whether the oil in the oil scale specified within the line, the oil quality is to meet the requirements, and according to the requirements to ensure filling, check whether the circulating water fill.     2 before driving should be idling warm car 15 minutes, observe the oil pressure is normal, again observe whether circulating cooling water to fill, and whether it is normal, there is no Water Leakage, oil leakage and leakage phenomenon.     3 every cold road before 10 ~ 15 km, transportation vehicle speed should be controlled at 40 kilometers per hour, the tractor should be controlled in less than 15 km, when the temperature reached 75 degrees above normal speed, it can ensure the cylinder sleeve, bearing and other parts are good lubrication and full, make each movement friction surface to grind the mirror surface, thereby greatly improving the service life of the diesel engine.     4 driving observe the diesel engine oil pressure, water temperature, sound, smoke and odor are normal, such as abnormal should immediately stop check, troubleshooting before it can continue to run, otherwise it will damage due to improper operation to expand fault.     5 must be running in according to the requirements. Because the machining surface finish and at the micro there is uneven, the running in process is actually to machining convex surface passivation, passivation and grinded by convex good abrasion resistance.     The 6 should always check the intake pipe of each interface has no leakage and breakage. If the leakage and breakage, will make the air with dust is not filtered directly into the combustion chamber, the cylinder liner wear intensifies, piston and piston ring. Recommended for every travel kilometers replacement of a CD grade oil 7 under normal circumstances, the oil drain shall be carried out in the oil temperature is higher, the oil drain plug on 4 hours do not twist, in order to put more than oil net with impurities.     The 8 paper air filter every travel kilometers to clean a filter, kilometers replacement of a filter core, a large amount of dust should shorten the replacement time. Air filter must buy the filter paper is good, good elasticity and genuine rubber pad. When installing the upper pad to contact on the plane, the lower end of the rubber pad pad to ensure peace with filter installed on the lower end face sealing good, plastic filter also don't leak loaded paper filter above (commonly known as coarse filter), the amount of coarse filter element of air filter bear 60%. Oil bath air filter according to the scale indication filling oil, and regular cleaning, replacement of oil.     9 Meng stepped on the accelerator fast speed and fierce tread the brake suddenly decelerate will damage parts. Half step clutch deceleration or a longer period of time step on the clutch can cause crankshaft wear body.     10 cooling water softening water must use, prohibited the use of hard water (well water, spring water), if use softening treatment.     11 high pressure oil pump adjustment need professional personnel, are not allowed to use adjustable high speed or increase the amount of oil.     12 user shall not be arbitrarily modified, otherwise the loss caused by the ego; if you have special requirements, can be ordered separately.     13 the winter freeze, cooling water should be filling antifreeze. Not filling antifreeze, should also open the drain valve of diesel engine and the water tank when the water is discharged, running at idle speed state water. The body of water can not put the net can freeze the body and pump.     1 of the reference to "address registration service station maintenance manual", the nearest service station to get in touch with.     2 and the local power stagnation point directly contact the business personnel.     3 dial service hotline: power.      1 without the Three Guarantees certificate, the Three Guarantees certificate had altered or odometer adjusted. Fault 2 according to the specified running or long-term serious overload caused by.     3 not according to the instructions provided with fuel, lubricating oil, cooling water. Not for 100 hours and 500 hours of maintenance.     4 cylinder cooling water caused by water shortage or too excited crack related components.     5 water freezing or other parts of the body.     6 the use of poor quality and not clean oil or lack of oil and oil pressure is too low cause of tile. Note: filling should pay oil grade and temperature. The 7 intake does not clean caused early wear of cylinder liner, piston and piston ring.     8 the use of inferior diesel oil card die head, or excessive carbon deposition caused by fracture failure of piston ring.     9 long time preheating, decrepitation glow plug or long time start burn starter.     10 traveling kilometers (or 8 months) for connecting rod bolts loosening caused by the connecting rod bolt fracture.     11 after failure of not maintaining undisturbed or damaged without the consent of sellers, mender agree, self treatment make the fault reason can not make a technical appraisal.     1 users to purchase a car repair personnel issued in an three pack service (machine) machine "warranty manual invoices and laidong diesel".     2 pack of three term and mileage in any one is in excess of three packets in excess of the prescribed period.     3 if the accurate measurement of the odometer unable, to run on 8 hours, with an average speed of 40 km / h to three packs of mileage calculation, single refitted according the method converted three packets of mileage.

    4 of users refused to normal dismantling repair personnel, will be regarded as giving up the pack of three rights. 

Are you interested in learning more about YUNNEI main bearing? Contact us today to secure an expert consultation!